Gj2 plot
PLP Plot profile on screen. Default is chemical and magnetic.
Append N for nuclear only; M for magnetic only; T for magnetic
angle. Append A, B, C, or D for scattering density for the
specified cross-sections. Append S for scattering density for
the cross-sections specified in PS. Data are saved in file
mltmp.prC where C is n, m, t, a, b, c, or d.
PRF Plot reflectivity on screen. Append A, B, C, or D for specific
cross-sections. Default uses value from PS.
MVc Enter a parameter name and watch as the reflectivity varies with
that parameter. Choose c to be one of R, D, I, S, or P. R plots
the reflectivities, D plots the ratio of successive frames to the
first frame, I plots the ratio of successive frames, S plots the
scattering densities, and P plots the nuclear, magnetic, and
magnetic angle profile. S is the default. Append A, B, C or D
for specific cross-sections. Default uses value from PS.
MVFc Plots a movie of the last fit progression. Choose c as in MV.
Append A, B, C or D for specific cross-sections. Default uses
value from PS.
MVXc Plots a movie of parameters tabulated in a file. Choose c as in
MV. Append A, B, C or D for specific cross-sections. Default uses
value from PS. The file is formatted with a line that begins
with # followed by a list of parameters to vary, separated with
spaces. The following lines (1 per frame) list the values to use
for each respective parameter, again seperated with spaces.
Browse
Index